Alcatel-Lucent 7210 SAS M - Page 724

Show, Clear, Debug Commands
Page 724 7210-SAS M Services Guide
Opr MTU
Specifies the actual largest service frame size (in octets) that can be
transmitted through this SDP to the far-end router, without requiring the
packet to be fragmented.
IP address
Specifies the IP address of the remote end of the GRE or MPLS tunnel
defined by this SDP.
Adm
Admin State
Specifies the state of the SDP.
Opr
Oper State
Specifies the operating state of the SDP.
Flags
Specifies all the conditions that affect the operating status of this SDP.
Signal
Signaling
Specifies the signaling protocol used to obtain the ingress and egress
labels used in frames transmitted and received on the SDP.
Last Status Change
Specifies the time of the most recent operating status change to this
SDP.
Last Mgmt Change
Specifies the time of the most recent management-initiated change to
this SDP.
Number of SDPs
Specifies the total number of SDPs displayed according to the criteria
specified.
Hello Time
Specifies how often the SDP echo request messages are transmitted on
this SDP.
Deliver
Delivered
Specifies the type of delivery used by the SDP: GRE or MPLS.
Number of SDPs
Specifies the total number of SDPs displayed according to the criteria
specified.
Hello Time
Specifies how often the SDP echo request messages are transmitted on
this SDP.
Hello Msg Len
Specifies the length of the SDP echo request messages transmitted on
this SDP.
Hello Timeout
Specifies the number of seconds to wait for an SDP echo response mes-
sage before declaring a timeout.
Unmatched Replies
Specifies the number of SDP unmatched message replies.
Max Drop Count
Specifies the maximum number of consecutive SDP echo request mes-
sages that can be unacknowledged before the keepalive protocol reports
a fault.
Hold Down Time
Specifies the maximum number of consecutive SDP echo request mes-
sages that can be unacknowledged before the keepalive protocol reports
a fault.
Label Description (Continued)