Alcatel-Lucent 7210 SAS M - Page 788

Show, Clear, Debug Commands
Page 788 7210-SAS M Services Guide
Sample Output
*A:ALA-12# show router 3 static-route
==============================================================================
Route Table
==============================================================================
IP Addr/mask Pref Metric Type Nexthop Interface Active
------------------------------------------------------------------------------
192.168.250.0/24 5 1 ID 10.200.10.1 to-ser1 Y
192.168.252.0/24 5 1 NH 10.10.0.254 n/a N
192.168.253.0/24 5 1 NH to-ser1 n/a N
192.168.253.0/24 5 1 NH 10.10.0.254 n/a N
192.168.254.0/24 4 1 BH black-hole n/a Y
==============================================================================
*A:ALA-12#
*A:ALA-12# show router 3 static-route 192.168.250.0/24
==============================================================================
Route Table
==============================================================================
IP Addr/mask Pref Metric Type Nexthop Interface Active
------------------------------------------------------------------------------
192.168.250.0/24 5 1 ID 10.200.10.1 to-ser1 Y
==============================================================================
*A:ALA-12#
*A:ALA-12# show router 3 static-route preference 4
=============================================================================
Route Table
==============================================================================
IP Addr/mask Pref Metric Type Nexthop Interface Active
------------------------------------------------------------------------------
192.168.254.0/24 4 1 BH black-hole n/a Y
==============================================================================
ID — The static route is an indirect route, where the nexthop for this
type of route is the non-directly connected next hop.
NH — The route is a static route with a directly connected next hop.
The
Nexthop for this type of route is either the next hop IP address or
an egress IP interface name.
Next Hop
The next hop for the static route destination.
Interface
The egress IP interface name for the static route.
n/a — indicates there is no current egress interface because the
static route is inactive or a black hole route.
Active
N — The static route is inactive; for example, the static route is dis-
abled or the next hop IP interface is down.
Y — The static route is active.
No. of Routes:
The number of routes displayed in the list.
Label Description (Continued)