Alcatel-Lucent 7210 SAS M - Page 830

Show, Clear, Debug Commands
Page 830 7210 SAS M Services Guide
===============================================================================
Service Id : 104 Vpn Id : 0
Service Type : Cpipe VLL Type : CESoPSN
Description : (Not Specified)
Customer Id : 1
Last Status Change: 12/15/2010 07:39:05
Last Mgmt Change : 12/15/2010 07:25:37
Admin State : Up Oper State : Up
MTU : 1514
Vc Switching : False
SAP Count : 1 SDP Bind Count : 1
-------------------------------------------------------------------------------
Service Access & Destination Points
-------------------------------------------------------------------------------
Identifier Type AdmMTU OprMTU Adm Opr
-------------------------------------------------------------------------------
sap:1/2/1.2 cem 1514 1514 Up Up
sdp:123:104 S(102.102.102.102) n/a 0 9190 Up Up
===============================================================================
*A:Dut-A>show# service id 104 base
===============================================================================
Service Basic Information
===============================================================================
Service Id : 104 Vpn Id : 0
Service Type : Cpipe VLL Type : CESoPSN
Description : (Not Specified)
Customer Id : 1
Last Status Change: 12/15/2010 07:39:05
Last Mgmt Change : 12/15/2010 07:25:37
Admin State : Up Oper State : Up
MTU : 1514
Vc Switching : False
SAP Count : 1 SDP Bind Count : 1
-------------------------------------------------------------------------------
Service Access & Destination Points
-------------------------------------------------------------------------------
Identifier Type AdmMTU OprMTU Adm Opr
-------------------------------------------------------------------------------
sap:1/2/1.2 cem 1514 1514 Up Up
sdp:123:104 S(102.102.102.102) n/a 0 9190 Up Up
===============================================================================
*A:Dut-A>show#
endpoint
Syntax endpoint [endpoint-name]
Context show>service>id
Description This command displays service endpoint information.
Parameters endpoint-name — Specifies the name of an existing endpoint for the service.
Sample Output