Alcatel-Lucent 7210 SAS M - Page 833

VLL Show Commands
7210 SAS M Services Guide Page 833
Encap
The encapsulation type of the SAP.
Ethertype
Specifies an Ethernet type II Ethertype value.
Admin State
The administrative state of the SAP.
Oper State
The operating state of the SAP.
Flags
Specifies the conditions that affect the operating status of this SAP.
Display output includes: ServiceAdminDown, SapAdminDown,
InterfaceAdminDown, PortOperDown, PortMTUTooSmall,
L2OperDown, SapEgressQoSMismatch,RelearnLimitExceeded,
RxProtSrcMac, ParentIfAdminDown, NoSapIpipeCeIpAddr,
TodResourceUnavail, TodMssResourceUnavail, SapParamMis-
match, ServiceMTUTooSmall, SapIngressNamedPoolMismatch,
SapEgressNamedPoolMismatch, NoSapEpipeRingNode.
Last Status Change
The time of the most recent operating status change to this SAP.
Last Mgmt Change
The time of the most recent management-initiated change to this SAP.
Admin MTU
The desired largest service frame size (in octets) that can be transmit-
ted through the port to the far-end router, without requiring the packet
to be fragmented.
Oper MTU
The actual largest service frame size (in octets) that can be transmitted
through the port to the far-end router, without requiring the packet to
be fragmented.
Ingress qos-pol-
icy
The ingress QoS policy ID assigned to the SAP.
Egress qos-policy
The egress QoS policy ID assigned to the SAP.
Ingress Filter-Id
The ingress filter policy ID assigned to the SAP.
Egress Filter-Id
The egress filter policy ID assigned to the SAP.
Acct. Pol
The accounting policy ID assigned to the SAP.
Collect Stats
Specifies whether collect stats is enabled.
LLF Admin State
Displays the Link Loss Forwarding administrative state.
LLF Oper State
Displays the Link Loss Forwarding operational state.
Loopback Mode
Displays the Ethernet port loop back mode
Loopback Src Addr
Displays the configured loopback source address
Loopback Dst Addr
Displays the configured loopback destination address
No-svc-port used
Displays the port ID of the port on which no service is configured.
This port is used for the port loop back with MAC swap functionality.
Label Description (Continued)