Alcatel-Lucent 7210 SAS M - Page 832

Show, Clear, Debug Commands
Page 832 7210 SAS M Services Guide
Sample Output
*A:ALA-12# show service id 1 labels
==============================================================================
Martini Service Labels
==============================================================================
Svc Id Sdp Id Type I.Lbl E.Lbl
------------------------------------------------------------------------------
1 10:1 Mesh 0 0
1 20:1 Mesh 0 0
1 30:1 Mesh 0 0
1 40:1 Mesh 130081 131061
1 60:1 Mesh 131019 131016
1 100:1 Mesh 0 0
------------------------------------------------------------------------------
Number of Bound SDPs : 6
------------------------------------------------------------------------------
*A:ALA-12#
sap
Syntax sap sap-id [detail]
Context show>service>id
Description This command displays information for the SAPs associated with the service. If no optional parame-
ters are specified, a summary of all associated SAPs is displayed.
Parameters sap-id — The ID that displays SAPs for the service in the form slot/mda/port[.channel]. See Common
CLI Command Descriptions on page 939 for command syntax.
interface interf ace-name — Displays information for the specified IP interface.
ip-address ip-address — Displays information associated with the specified IP address.
detail — Displays detailed information.
detail — Displays detailed information for the SAP.
Output Show Service-ID SAP — The following table describes show service SAP fields:
I. Lbl
The VC label used by the far-end device to send packets to this device
in this service by the SDP.
E. Lbl
The VC label used by this device to send packets to the far-end device
in this service by the SDP.
Label Description (Continued)
Label Description
Service Id
The service identifier.
SAP
The SAP and qtag.