Alcatel-Lucent 7210 SAS M Service Guide

VPLS Show Commands
7210 SAS M Services Guide Page 867
sap-using
Syntax sap-using interface [ip-address | ip-int-name]
sap-using [ingress | egress] filter filter-id
sap-using [sap sap-id]
sap-using [ingress] qos-policy qos-policy-id
Context show>service
Description This command displays SAP information.
If no optional parameters are specified, the command displays a summary of all defined SAPs.
The optional parameters restrict output to only SAPs matching the specified properties.
Parameters ingress — Specifies matching an ingress policy.
egress — Specifies matching an egress policy.
filter filter-id — The ingress or egress filter policy ID for which to display matching SAPs.
Values 1 — 65535
sap-id — Specifies the physical port identifier portion of the SAP definition. See Common CLI
Command Descriptions on page 939 for command syntax.
Output Show Service SAP — The following table describes show service SAP output fields:
i
Sample Output
*A:ALU_SIM2>config>service>vpls# show service sap-using
===============================================================================
Service Access Points
===============================================================================
PortId SvcId Ing. Ing. Egr. Adm Opr
QoS Fltr Fltr
-------------------------------------------------------------------------
1/1/1:10 1 1 none 1none Up Up
1/1/3:500.* 1 1 none 1none Up Up
Label Description
Port ID
The ID of the access port where the SAP is defined.
Svc ID
The service identifier.
I.QoS
The SAP ingress QoS policy number specified on the ingress SAP.
I.MAC/IP
The MAC or IP filter policy ID applied to the ingress SAP.
Egr. Fltr
The filter policy ID applied to the egress SAP.
A.Pol
The accounting policy ID assigned to the SAP.
Adm
The administrative state of the SAP.
Opr
The actual state of the SAP.

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English