Show, Clear, Debug Commands
Page 876 7210 SAS M Services Guide
Hold Down Time
Specifies the amount of time to wait before the keepalive operating sta-
tus is eligible to enter the alive state.
SDP Delivery Mech-
anism
When the SDP type is MPLS, a list of LSPs used to reach the far-end
router displays. All the LSPs in the list must terminate at the IP address
specified in the Far End field.
If the SDP type is GRE, then the following message displays:
SDP Delivery Mechanism is not MPLS
Number of SDPs
The total number SDPs applied to this service ID.
Service Id
The service identifier.
Port Id
The ID of the access port where this SAP is defined.
Description
Generic information about the SAP.
Encap Value
The value of the label used to identify this SAP on the access port.
Admin State
The administrative state of the SAP.
Oper State
The operating state of the SAP.
Last Changed
The date and time of the last change.
Admin MTU
The desired largest service frame size (in octets) that can be transmit-
ted through this SDP to the far-end router, without requiring the packet
to be fragmented.
Oper MTU
The actual largest service frame size (in octets) that can be transmitted
through this SDP to the far-end router, without requiring the packet to
be fragmented.
Ingress qos-pol-
icy
The SAP ingress QoS policy ID.
Ingress Filter-Id
The SAP ingress filter policy ID.
Egress Filter-Id
The SAP egress filter policy ID.
Multi Svc Site
Indicates the multi-service site that the SAP is a member.
Ingress sched-
policy
Indicates the ingress QoS scheduler for the SAP.
Egress sched-pol-
icy
Indicates the egress QoS scheduler for the SAP.
Acct. Pol
Indicates the accounting policy applied to the SAP.
Collect Stats
Specifies whether accounting statistics are collected on the SAP.
Ingress Stats
The number of received packets/octets for this SAP.
Egress Stats
The number of packets/octets forwarded out of this SAP.
Ingress Meter 1
The index of the ingress QoS meter of this SAP.
Label Description (Continued)
To Next Page
Loading...
Need help?
General
