VPLS Show Commands
7210 SAS M Services Guide Page 877
Sample Output
A:Dut-A>config>service# show service id 305 all
===============================================================================
Service Detailed Information
===============================================================================
Service Id : 305 Vpn Id : 305
Service Type : uVPLS
Description : Default tls description for service id 305
Customer Id : 1
Last Status Change: 07/07/2009 14:39:57
Last Mgmt Change : 07/07/2009 14:39:14
Admin State : Up Oper State : Up
MTU : 1514
MTU Check : Disabled
SAP Count : 2 SDP Bind Count : 4
Send Flush on Fail: Disabled
Uplink Type : MPLS
Propagate MacFlush: Disabled
-------------------------------------------------------------------------------
Service Destination Points(SDPs)
-------------------------------------------------------------------------------
Sdp Id 1217:305 -(10.20.1.2)
-------------------------------------------------------------------------------
Description : Default sdp description
SDP Id : 1217:305 Type : Spoke
VC Type : Ether VC Tag : n/a
Admin Path MTU : 0 Oper Path MTU : 9186
High priority
offered
The packets or octets count of the high priority traffic for the SAP.
For.InProf
The packets or octets count of the in-profile forwarded traffic for the
SAP.
For.OutProf
The number of out of profile traffic packets/octets forwarded.
Managed by Service
Specifies the service-id of the management VPLS managing this SAP.
Managed by MSTI
Specifies the MST instance inside the management VPLS managing
this SAP.
Last BPDU from
The bridge ID of the sender of the last BPDU received on this SAP.
Managed by SAP
Specifies the sap-id inside the management VPLS managing this SAP.
Prune state
Specifies the STP state inherited from the management VPLS.
Managed by Service
Specifies the service-id of the management VPLS managing this spoke
SDP.
Last BPDU from
The bridge ID of the sender of the last BPDU received on this SAP.
Managed by Spoke
Specifies the sap-id inside the management VPLS managing this spoke
SDP.
Prune state
Specifies the STP state inherited from the management VPLS.
Label Description (Continued)