VPLS Show Commands
7210 SAS M Services Guide Page 889
Service Id : 1 Mac Move : Disabled
Mac Move Rate : 2 Mac Move Timeout : 10
Mac Move Retries : 3
Table Size : 250 Total Count : 0
Learned Count : 0 Static Count : 0
Remote Age : 900 Local Age : 300
High Watermark : 95% Low Watermark : 90%
Mac Learning : Enabled Discard Unknown : Disabled
Mac Aging : Enabled Relearn Only : False
-------------------------------------------------------------------------------
Service Endpoints
-------------------------------------------------------------------------------
No Endpoints found.
===============================================================================
*A:SAS-M-A0-2>show>service>id#
arp
Syntax arp [ip-address] | [mac ieee-address] | [sap sap-id] | [interface ip-int-name]
Context show>service>id
Description This command displays the ARP table for the VPLS instance. The ARP entries for a subscriber
interface are displayed uniquely. Each MAC associated with the subscriber interface child group-
interfaces is displayed with each subscriber interface ARP entry for easy lookup.
Parameters ip-address — All IP addresses.
mac ieee-address — Displays only ARP entries in the ARP table with the specified 48-bit MAC
address. The MAC address is in the form aa:bb:cc:dd:ee:ff or aa-bb-cc-dd-ee-ff, where aa, bb, cc,
dd, ee and ff are hexadecimal numbers.
Default All MAC addresses.
sap sap-id — Displays SAP information for the specified SAP ID.
interface — Specifies matching service ARP entries associated with the IP interface.
ip-address — The IP address of the interface for which to display matching ARP entries.
Values 1.0.0.0 — 223.255.255.255
ip-int-name — The IP interface name for which to display matching ARPs.
Output Show Service-ID ARP — The following table describes show service-id ARP output fields.
Label Description
IP Address
The IP address.
MAC Address
The specified MAC address.
Type Static — FDB entries created by management.
Learned — Dynamic entries created by the learningprocess.