Alcatel-Lucent 7210 SAS M - Page 895

VPLS Show Commands
7210 SAS M Services Guide Page 895
Sample Output
A:Dut-A# show service id 305 labels
===============================================================================
Martini Service Labels
===============================================================================
Svc Id Sdp Binding Type I.Lbl E.Lbl
-------------------------------------------------------------------------------
305 1217:305 Spok 130506 130516
305 1317:305 Spok 130454 130591
305 1417:305 Spok 130428 131015
305 1617:305 Spok 131060 130843
-------------------------------------------------------------------------------
Number of Bound SDPs : 4
===============================================================================
A:Dut-A#
l2pt
Syntax l2pt disabled
l2pt [detail]
Context show>service>id
Description This command displays Layer 2 Protocol Tunnel (L2-PT) route information associated with this
service.
Parameters disabled — Displays only entries with termination disabled. This helps identify configuration errors.
detail — Displays detailed information.
Output Show L2PT Fields — The following table describes show L2PT output fields:
Type
Indicates whether the SDP is spoke.
I. Lbl
The VC label used by the far-end device to send packets to this device
in this service by the SDP.
E. Lbl
The VC label used by this device to send packets to the far-end device
in this service by the SDP.
Label Description
Label Description
Service id
Displays the 24 bit (0..16777215) service instance identifier for the
service.
L2pt-term enabled
Indicates if L2-PT-termination and/or Bpdu-translation is in use in this
service by at least one SAP or spoke SDP binding. If in use, at least
one of L2PT-termination or Bpdu-translation is enabled.
When enabled it is not possible to enable STP on this service.