VPLS Show Commands
7210 SAS M Services Guide Page 899
Sample Output
A:7210>show>service>id# sap 1/1/1:1 detail
===============================================================================
Service Access Points(SAP)
===============================================================================
Service Id : 1
SAP : 1/1/1:1 Encap : q-tag
Description : (Not Specified)
Admin State : Up Oper State : Down
Flags : ServiceAdminDown
Last Status Change : 10/05/2010 07:22:04
Last Mgmt Change : 10/05/2010 07:22:05
Dot1Q Ethertype : 0x8100 QinQ Ethertype : 0x8100
Max Nbr of MAC Addr: No Limit Total MAC Addr : 0
Learned MAC Addr : 0 Static MAC Addr : 0
Admin MTU : 1518 Oper MTU : 1518
Ingr IP Fltr-Id : n/a Egr IP Fltr-Id : n/a
Ingr Mac Fltr-Id : n/a Egr Mac Fltr-Id : n/a
tod-suite : None
Mac Learning : Enabled Discard Unkwn Srce: Disabled
Mac Aging : Enabled Mac Pinning : Disabled
SAP per Meter stats
Ingress Meter
Specifies the meter ID.
For. InProf
The number of in-profile packets and octets (rate below CIR) for-
warded.
For. OutProf
The number of out-of-profile packets and octets. (rate above CIR and
below PIR) forwarded by the ingress meter.
Ingress TD Profile
The profile ID applied to the ingress SAP.
Egress TD Profile
The profile ID applied to the egress SAP.
Alarm Cell Han-
dling
The indication that OAM cells are being processed.
AAL-5 Encap
The AAL-5 encapsulation type.
Aggregate Policer
rate-indicates the rate of the aggregate policer.
burst-indicates the burst-size of the aggregate policer.
Loopback Mode
Displays the Ethernet port loopback mode
Loopback Src Addr
Displays the configured loopback source address
Loopback Dst Addr
Displays the configured loopback destination address
No-svc-port used
Displays the port ID of the port on which no service is configured.
This port is used for the port loop back with MAC swap functionality.
Label Description (Continued)
To Next Page
Loading...
Need help?
General
