Show, Clear, Debug Commands
Page 902 7210 SAS M Services Guide
Ingress qos-policy : 1
-------------------------------------------------------------------------------
Aggregate Policer
-------------------------------------------------------------------------------
rate : n/a burst : n/a
-------------------------------------------------------------------------------
Ingress QoS Classifier Usage
-------------------------------------------------------------------------------
Classifiers Allocated: 4 Meters Allocated : 2
Classifiers Used : 2 Meters Used : 2
-------------------------------------------------------------------------------
Sap Statistics
-------------------------------------------------------------------------------
Packets Octets
Ingress Stats: 142761481188 9707780720784
Egress Stats: 0 0
Extra-Tag Drop Stats: n/a n/a
-------------------------------------------------------------------------------
Sap per Meter stats
-------------------------------------------------------------------------------
Packets Octets
Ingress Meter 1 (Unicast)
For. InProf : 17 1162
For. OutProf : 0 0
Ingress Meter 11 (Multipoint)
For. InProf : 61 4148
For. OutProf : 142761547917 9707785259394
===============================================================================
sdp
Note : SDP commands are not supported by 7210 SAS-M devices configured in Access uplink mode.
Syntax sdp [sdp-id | far-end ip-addr] [detail]
Context show>service>id
Description This command displays information for the SDPs associated with the service. If no optional
parameters are specified, a summary of all associated SDPs is displayed.
Parameters sdp-id — Displays only information for the specified SDP ID.
Default All SDPs
Values 1 — 17407
far-end ip-addr — Displays only SDPs matching with the specified far-end IP address.
Default SDPs with any far-end IP address.
detail — Displays detailed SDP information.
Output Show Service-ID SDP — The following table describes show service-id SDP output fields.
To Next Page
Loading...
