Show, Clear, Debug Commands
Page 924 7210 SAS M Services Guide
===============================================================================
*A:MTU-7210#
*A:MTU-T2# show service id 100 igmp-snooping proxy-db detail
===============================================================================
IGMP Snooping Proxy-reporting DB for service 100
===============================================================================
-------------------------------------------------------------------------------
IGMP Group 227.7.7.7
-------------------------------------------------------------------------------
Up Time : 0d 00:05:43
-------------------------------------------------------------------------------
IGMP Group 227.7.7.8
-------------------------------------------------------------------------------
Up Time : 0d 00:05:43
-------------------------------------------------------------------------------
IGMP Group 228.8.8.8
-------------------------------------------------------------------------------
Up Time : 0d 00:03:55
-------------------------------------------------------------------------------
Number of groups: 3
===============================================================================
*A:MTU-7210#
querier
Syntax querier
Context show>service>id>igmp-snooping
Description This command displays information on the IGMP snooping queriers for the VPLS service.
Output Show Output — The following table describes the show output fields:
Label Description
SAP Id
Specifies the SAP ID of the service.
IP address
Specifies the IP address of the querier.
Expires
The time left, in seconds, that the query will expire.
Up time
The length of time the query has been enabled.
Version
The configured version of IGMP.
General Query
Interval
The frequency at which host-query packets are transmitted.
Query Response
Interval
The time to wait to receive a response to the host-query message
from the host.
Robust Count
Specifies the value used to calculate several IGMP message intervals.
To Next Page
Loading...
Need help?
General
