Alcatel-Lucent 7210 SAS M - Page 928

Show, Clear, Debug Commands
Page 928 7210 SAS M Services Guide
Message Type Received Transmitted Forwarded
-------------------------------------------------------------------------------
General Queries 816014 0 816014
Group Queries 0 0 0
Group-Source Queries 0 0 0
V1 Reports 0 0 0
V2 Reports 18134 11991 0
V3 Reports 0 0 0
V2 Leaves 0 0 0
Unknown Type 0 N/A 0
-------------------------------------------------------------------------------
Drop Statistics
-------------------------------------------------------------------------------
Bad Length : 0
Bad IP Checksum : 0
Bad IGMP Checksum : 0
Bad Encoding : 0
No Router Alert : 0
Zero Source IP : 0
Wrong Version : 0
Lcl-Scope Packets : 0
Send Query Cfg Drops : 0
Import Policy Drops : 0
Exceeded Max Num Groups : 0
Exceeded Max Num Sources : 0
===============================================================================
A:7210-SAS>show>service>id#
endpoint
Syntax endpoint [endpoint-name]
Context show>service>id
Description This command displays service endpoint information.
Parameters endpoint-name — Specifies an endpoint name created in the config>service>vpls context.
Sample Output
*A:Dut-B# show service id 1 endpoint
===============================================================================
Service 1 endpoints
===============================================================================
Endpoint name : mcep-t1
Description : (Not Specified)
Revert time : 0
Act Hold Delay : 0
Ignore Standby Signaling : false
Suppress Standby Signaling : false
Block On Mesh Fail : true
Psv Mode Active : No
Tx Active : 231:1
Tx Active Up Time : 0d 00:06:57
Revert Time Count Down : N/A
Tx Active Change Count : 5