VPLS Show Commands
7210 SAS M Services Guide Page 927
Parameters sap sap-id — Displays IGMP snooping statistics for a specific SAP. See Common CLI Command
Descriptions on page 939 for command syntax.
sdp sdp-id — Displays the IGMP snooping statistics for a specific spoke or mesh SDP.
Values 1 — 17407
vc-id — The virtual circuit ID on the SDP ID for which to display information.
Default For mesh SDPs only, all VC IDs.
Values 1 — 4294967295
Sample Output
Sample Output (SAS-M in network mode)
*A:7210-SAS>show>service>id>igmp-snooping# statistics
===============================================================================
IGMP Snooping Statistics for service 2
===============================================================================
Message Type Received Transmitted Forwarded
-------------------------------------------------------------------------------
General Queries 0 0 0
Group Queries 0 0 0
V1 Reports 0 0 0
V2 Reports 142207 0 0
V2 Leaves 0 0 0
Unknown Type 0 N/A 0
-------------------------------------------------------------------------------
Drop Statistics
-------------------------------------------------------------------------------
Bad Length : 0
Bad IP Checksum : 0
Bad IGMP Checksum : 0
Bad Encoding : 0
No Router Alert : 0
Zero Source IP : 0
Wrong Version : 0
Lcl-Scope Packets : 0
Send Query Cfg Drops : 0
Import Policy Drops : 0
Exceeded Max Num Groups : 0
MCS Failures : 0
MVR From VPLS Cfg Drops : 142130
MVR To SAP Cfg Drops : 0
===============================================================================
*A:7210-SAS>show>service>id>igmp-snooping#
Sample Output (SAS-M in access-uplink mode)
A:7210-SAS>show>service>id# igmp-snooping statistics
===============================================================================
IGMP Snooping Statistics for service 1
===============================================================================
To Next Page
Loading...
Need help?
General
