Alcatel-Lucent 7750 SR - Page 1009

IES Service Configuration Commands
7750 SR OS Services Guide Page 1009
ETH-CFM Service Commands
eth-cfm
Syntax eth-cfm
Context config>service>ies>if>sap
config>service>ies>if>spoke-sdp
config>service>ies>sub-if>grp-if>
Description This command enables the context to configure ETH-CFM parameters.
mep
Syntax mep mep-id domain md-index association ma-index [direction {up | down}]
no mep mep-id domain md-index association ma-index
Context config>service>ies>if>sap>eth-cfm
config>service>ies>if>spoke-sdp>eth-cfm
config>service>ies>sub-if>grp-if>sap>eth-cfm
Description This command configures a SAP or spoke SDP ETH-CFM maintenance endpoint (MEP).
Parameters mep-id — Specifies the maintenance association end point identifier.
Values 1 — 8191
md-index — Specifies the maintenance domain (MD) index value.
Values 1 — 4294967295
ma-index — Specifies the MA index value.
Values 1 — 4294967295
direction up|down — Indicates the direction in which the maintenance association (MEP or MIP)
faces on the bridge port.
down — Sends continuity check messages away from the MAC relay entity.
up — Sends continuity check messages towards the MAC relay entity.
ccm-enable
Syntax [no] ccm-enable
Context config>service>ies>if>sap>eth-cfm>mep
config>service>ies>if>spoke-sdp>eth-cfm>mep
Description This command enables the generation of CCM messages.