Alcatel-Lucent 7750 SR - Figure 96: PW-Template CLI Tree; Figure 97: PW-Template-Bind CLI Syntax

Page 578 7750 SR OS Services Guide
Figure 96: PW-Template CLI Tree
A pw-template-bind command configured within the VPLS service under the bgp-ad sub-
command is a pointer to the pw-template that should be used. If a VPLS service does not specify
an import-rt list, then that binding applies to all route targets accepted by that VPLS. The pw-
template-bind command can select a different template on a per import-rt basis. It is also possible
to specify specific pw-templates for some route targets with a VPLS service and use the single pw-
template-bind command to address all unspecified but accepted imported targets.
Figure 97: PW-Template-Bind CLI Syntax
PERs6>config>service# pw-template 1 create
- [no] pw-template <policy-id> [use-provisioned-sdp]
<policy-id> : [1..2147483647]
<use-provisioned-s*> : keyword
[no] accounting-pol* - Configure accounting-policy to be used
[no] collect-stats - Enable/disable statistics collection
[no] disable-aging - Enable/disable aging of MAC addresses
[no] disable-learni* - Enable/disable learning of new MAC addresses
[no] discard-unknow* - Enable/disable discarding of frames with unknown
source MAC address
egress + Spoke SDP binding egress configuration
igmp-snooping + Configure IGMP snooping parameters
ingress + Spoke SDP binding ingress configuration
[no] limit-mac-move - Configure mac move
[no] mac-pinning - Enable/disable MAC address pinning on this spoke SDP
[no] max-nbr-mac-ad* - Configure the maximum number of MAC entries in the FDB
from this SDP
[no] split-horizon-* + Configure a split horizon group
vc-type - Configure VC type
[no] vlan-vc-tag - Configure VLAN VC tag
PERs6>config>service>vpls>bgp-ad# pw-template-bind
- pw-template-bind <policy-id> [split-hozion-group <group-name>] [import-rt
{ext-community, ...(upto 5 max)}]
- no pw-template-bind <policy-id>
<policy-id> : [1..2147483647]
<group-name> : [32 chars max]
<ext-community> : target:{<ip-addr:comm-val>|<as-number:ext-comm-val>}
ip-addr - a.b.c.d
comm-val - [0..65535]
as-number - [1..65535]
ext-comm-val - [0..4294967295]