Virtual Leased Line Services
7750 SR OS Services Guide Page 239
Configuring a VLL Service with CLI
This section provides information to configure Virtual Leased Line (VLL) services using the
command line interface.
Topics in this section include:
• Basic Configurations on page 241
• Common Configuration Tasks on page 241
→ Configuring VLL Components on page 242
− Creating an Apipe Service on page 242
− Creating a Cpipe Service on page 249
− Creating an Epipe Service on page 253
− Creating an Fpipe Service on page 265
− Creating an Ipipe Service on page 270
− Using Spoke SDP Control Words on page 274
− Same Fate Epipe VLANs Access Protection on page 275
→ Configuring Pseudowire Scenarios
− Pseudowire Configuration Notes on page 277
− Configuring Two VLL Paths Terminating on T-PE2 on page 279
− Configuring VLL Resilience on page 282
− Configuring VLL Resilience for a Switched Pseudowire Path on page 283
• Service Management Tasks on page 285
Apipe:
→ Modifying Apipe Service Parameters on page 286
→ Disabling an Apipe Service on page 288
→ Re-enabling an Apipe Service on page 289
→ Deleting an Apipe Service on page 290
Cpipe
→ Modifying a Cpipe Service on page 291
→ Deleting a Cpipe Service on page 292
Epipe:
→ Modifying Epipe Service Parameters on page 293
→ Deleting an Epipe Service on page 294
→ Re-enabling an Epipe Service on page 294
→ Re-enabling an Epipe Service on page 294
To Next Page
