Virtual Private LAN Services
7750 SR OS Services Guide Page 509
Configuring a VPLS Service with CLI
VPLS This section provides information to configure VPLS services using the command line interface.
Topics in this section include:
• Basic Configuration on page 510
• Common Configuration Tasks on page 512
→ Configuring VPLS Components on page 513
− Creating a VPLS Service on page 515
− Configuring a VPLS SAP on page 525
• Local VPLS SAPs on page 525
• Distributed VPLS SAPs on page 526
• Configuring SAP Subscriber Management Parameters on page 538
− MSTP Control over Ethernet Tunnels on page 539
− Configuring SDP Bindings on page 540
• Configuring VPLS Redundancy on page 553
− Creating a Management VPLS for SAP Protection on page 553
− Creating a Management VPLS for Spoke SDP Protection on page 556
− BGP VPLS Configuration Example on page 574
− Configuring Multi-Chassis Endpoints on page 565
• ATM/Frame Relay PVC Access and Termination on a VPLS Service on page 569
• Configuring Provider Edge Discovery Policies on page 580
→ Applying a PE Discovery Policy to a VPLS Service on page 582
• Configuring Policy-Based Forwarding for Deep Packet Inspection (DPI) in VPLS on page
583
• Service Management Tasks on page 586
→ Modifying VPLS Service Parameters on page 586
→ Modifying Management VPLS Parameters on page 587
→ Deleting a VPLS Service on page 589
→ Disabling a VPLS Service on page 589
→ Re-Enabling a VPLS Service on page 590
To Next Page
