Configuring an IES Service with CLI
Page 888 7750 SR OS Services Guide
Configuring SAP Parameters
IES SAP
A SAP is a combination of a port and encapsulation parameters which identifies the service access
point on the interface and within the router. Each SAP must be unique within a router.
When configuring IES SAP parameters, a default QoS policy is applied to each ingress and egress
SAP. Additional QoS policies and scheduler policies must be configured in the
config>qos
context. Filter policies are configured in the config>filter context and must be explicitly applied to
a SAP. There are no default filter policies.
IES interface ATM SAP parameters can only be configured on ATM-type MDAs and ATM-
configured ports. See the 7750 SR OS Basic System Configuration Guide.
Refer to IES Services Command Reference on page 897 for CLI syntax.
This example displays an IES SAP configuration.
*A:ALA-A>config>service>ies>if# info
----------------------------------------------
address 10.10.36.2/24
sap 5/1/3.1:0 create
ingress
qos 101
exit
egress
scheduler-policy "alpha"
qos 1010
exit
exit
----------------------------------------------
*A:ALA-A>config>service>ies>if#
To Next Page
Loading...
