Alcatel-Lucent 7750 SR - Configuring an SDP

Services
7750 SR OS Services Guide Page 95
Configuring an SDP
Use the following CLI syntax to create an SDP and select an encapsulation type. If you do not
specify GRE or MPLS, the default encapsulation type is GRE.
NOTE: When you specify the far-end ip address, you are creating the tunnel. In essence, you are
creating the path from Point A to Point B. When you configure a distributed service, you must
identify an SDP ID. Use the show service sdp command to display the qualifying SDPs.
When specifying MPLS SDP parameters, you must specify an LSP or enable LDP. There cannot
be 2 methods of transport in a single SDP. If an LSP name is specified, then RSVP is used for
dynamic signaling within the LSP.
LSPs are configured in the config>router>mpls context. See the 7750 SR OS MPLS Guidefor
configuration and command information.
Use the following CLI syntax to create a GRE SDP or an MPLS SDP:
CLI Syntax: config>service>sdp sdp-id [gre | mpls] create
adv-mtu-override
description description-string
far-end ip-address
keep-alive
hello-time seconds
hold-down-time seconds
max-drop-count count
message-length octets
timeout timeout
no shutdown
ldp (only for MPLS SDPs)
lsp lsp-name [lsp-name](only for MPLS SDPs)
path-mtu octets
signaling {off | tldp}
no shutdown