Alcatel-Lucent 7750 SR - Basic Configuration

Services
7750 SR OS Services Guide Page 89
Basic Configuration
The most basic service configuration must have the following:
•A customer ID
• A service type
• A service ID
An optional service name can also be configured in addition to the service ID. Service
names are optional. All services are required to assign a service ID to initially create a
service. However, either the service ID or the service name can be used to identify and
reference a given service once it is initially created.
• A SAP identifying a port and encapsulation value
• An interface (where required) identifying an IP address, IP subnet, and broadcast address
• For distributed services: an associated SDP
The following example provides an Epipe service configuration displaying the SDP and Epipe
service entities. SDP ID 2 was created with the far-end node 10.10.10.104. Epipe ID 6000 was
created for customer ID 6 which uses the SDP ID 2.
A:ALA-B>config>service# info detail
#------------------------------------------
...
sdp 2 gre create
description "GRE-10.10.10.104"
far-end 10.10.10.104
signaling tldp
no vlan-vc-etype
keep-alive
path-mtu 4462
keep-alive
shutdown
hello-time 10
hold-down-time 10
max-drop-count 3
timeout 5
no message-length
exit
no shutdown
exit
...
epipe 6000 customer 6 vpn 6000 create
service-name “customer-ABC-NW” (R8.0)
service-mtu 1514
sap 1/1/2:0 create
no multi-service-site
ingress
no scheduler-policy
qos 1
exit
egress