Versatile Service Module
7750 SR OS Services Guide Page 1443
Common Configuration Tasks
This section provides a brief overview of the tasks that should be performed to configure VSM on
an MDA, router, router interface, and services.
• Provision one or more CCA as MDAs in the system.
• Create VSM CCAGs on the system.
• Provision CCAG path bandwidth, path weighting, and overall bandwidth parameters.
• Provision member CCAs into a CCAG.
• Provision service SAPs using a CCAG, path, and CCID for cross connect purposes.
• Bind routed network IP interfaces to a CCAG, path, and CCID for cross connect purposes.
Configure VSM CCAG Components
Use the CLI syntax displayed below to configure the following entities:
• Provision VSM on an MDA on page 1443
• Cross Connecting Network IP Interfaces on page 1448
• Provision CCAG Parameters on page 1445
• Configure Path Components on page 1446
• Cross Connecting Services on page 1449
Provision VSM on an MDA
Before a CCA module may be utilized in the system, the CCA must be provisioned into an MDA
slot. The MDA provisioning command must be modified to support provisioning a CCA adaptor
type. Up to 8 member CCAs can be configured per CCAG.
CLI Syntax: config>card# mda mda-number mda-type {other-MDA-type|cca}
The following example displays the command usage to provision CCA on an MDA:
Example:config# card 10
config>card# mda 1
config>card>mda# mda-type vsm-cca
config>card>mda# exit
config>card#
To Next Page
Loading...
