Alcatel-Lucent 7750 SR - Figure 85: Sdps - Uni-Directional Tunnels

Page 542 7750 SR OS Services Guide
Figure 85: SDPs — Uni-Directional Tunnels
Use the following CLI syntax to create a mesh or spoke SDP bindings with a distributed VPLS
service. SDPs must be configured prior to binding. Refer to Configuring an SDP on page 94 for
information about creating SDPs.
Use the following CLI syntax to configure mesh SDP bindings:
CLI Syntax: config>service# vpls service-id
Mesh SDP
mesh-sdp sdp-id[:vc-id] [vc-type {ether | vlan}]
egress
filter {ip ip-filter-id|mac mac-filter-id}
mfib-allowed-mda-destinations
mda mda-id
vc-label egress-vc-label
ingress
filter {ip ip-filter-id|mac mac-filter-id}
vc-label ingress-vc-label
no shutdown
static-mac ieee-address
vlan-vc-tag 0..4094
OSSG032
VPLS 9000
for
Customer 6001
VPLS 9000
for
Customer 6001
VPLS 9000
for
Customer 6001
ALA-1 ALA-2
ALA-3
MTU CMTU A
MTU B
MESH-SDP 3
MESH-SDP 4
MESH-SDP 4
MESH-SDP 6
MESH-SDP 5
MESH-SDP 5
Spoke-SDP 21
Spoke-SDP 22
Spoke-SDP 11
Spoke-SDP 10
Spoke-SDP 50
Spoke-SDP 51