Alcatel-Lucent 7750 SR - Configuring Egress Multicast Groups

Page 514 7750 SR OS Services Guide
Configuring Egress Multicast Groups
Use the following CLI syntax to configure egress multicast groups:
CLI Syntax: config>service# egress-multicast-group group-name
description description-string
dest-chain-limit [destinations per pass]
sap-common-requirements
dot1q-etype 0x0600..0xffff
egress-filter [ip ip-filter-id]
egress-filter [ipv6 ipv6-filter-id]
egress-filter [mac mac-filter-id]
qinq-etype [0x0600..0xffff]
qinq-fixed-tag-value tag-value
The following example displays an egress multicast group configuration:
A:ALA-48>config>service>egress-multicast-group# info
---------------------------------------------
dest-chain-limit 10
sap-common-requirements
dot1q-etype 0x060e
egress-filter ip 10
exit
---------------------------------------------
A:ALA-48>config>service>egress-multicast-group#