Alcatel-Lucent 7750 SR - Configuring VPRN Components; Creating a VPRN Service

Virtual Private Routed Network Services
7750 SR OS Services Guide Page 1103
Configuring VPRN Components
This section provides VPRN configuration examples for the following entities:
• Creating a VPRN Service on page 1103
• Configuring Global VPRN Parameters on page 1104
• Configuring VPRN Protocols - PIM on page 1106
• Configuring Router Interfaces on page 1107
• Configuring VPRN Protocols - OSPF on page 1113
• Configuring a VPRN Interface SAP on page 1115
• Configuring VPRN Protocols - BGP on page 1108
• Configuring VPRN Protocols - RIP on page 1111
VP RN param eters
Creating a VPRN Service
Use the following CLI syntax to create a VRPN service. A route distinguisher must be defined in
order for VPRN to be operationally active.
CLI Syntax: config>service# vprn service-id [customer customer-id]
route-distinguisher [ip-address:number1 | asn:number2]
description description-string
no shutdown
The following example displays a VPRN service configuration.
*A:ALA-1>config>service# info
----------------------------------------------
...
vprn 1 customer 1 create
route-distinguisher 10001:0
no shutdown
exit
...
----------------------------------------------
*A:ALA-1>config>service>vprn#