Alcatel-Lucent 7750 SR - Service Management Tasks; Modifying VPLS Service Parameters

Page 586 7750 SR OS Services Guide
Service Management Tasks
This section discusses the following service management tasks:
• Modifying VPLS Service Parameters on page 586
• Modifying Management VPLS Parameters on page 587
• Deleting a Management VPLS on page 587
• Disabling a Management VPLS on page 588
• Deleting a VPLS Service on page 589
Modifying VPLS Service Parameters
You can change existing service parameters. The changes are applied immediately.
To display a list of services, use the
show service service-using vpls command. Enter the
parameter such as description, SAP, SDP, and/or service-MTU command syntax, and then enter
the new information.
The following displays a modified VPLS configuration.
*A:ALA-1>config>service>vpls# info
----------------------------------------------
description "This is a different description."
disable-learning
disable-aging
discard-unknown
local-age 500
remote-age 1000
stp
shutdown
exit
sap 1/1/5:22 create
description "VPLS SAP"
exit
spoke-sdp 2:22 create
exit
no shutdown
----------------------------------------------
*A:ALA-1>config>service>vpls#