IES Service Configuration Commands
7750 SR OS Services Guide Page 1011
errXcon Only DefErrorCCM and DefXconCCM
xcon Only DefXconCCM; or
noXcon No defects DefXcon or lower are to be reported
mac-address
Syntax mac-address mac-address
no mac-address
Context config>service>ies>if>sap>eth-cfm>mep
config>service>ies>if>spoke-sdp>eth-cfm>mep
Description This command specifies the MAC address of the MEP.
The no form of this command reverts the MAC address of the MEP back to that of the port (if the
MEP is on a SAP) or the bridge (if the MEP is on a spoke).
Parameters mac-address — Specifies the MAC address of the MEP.
Values 6-byte MAC address in the form of xx:xx:xx:xx:xx:xx or xx-xx-xx-xx-xx-xx of the
MEP. Must be unicast. Using the all zeros address is equivalent to the no form of
this command.
To Next Page
Loading...
