IES Service Configuration Commands
7750 SR OS Services Guide Page 1041
mac
Syntax mac mac-address
no mac
Context config>service>ies>if>vrrp
Description This command assigns a specific MAC address to an IES IP interface.
The no form of the command returns the MAC address of the IP interface to the default value.
Default The physical MAC address associated with the Ethernet interface that the SAP is configured on (the
default MAC address assigned to the interface, assigned by the system).
Parameters mac-address — Specifies the 48-bit MAC address for the static ARP in the form aa:bb:cc:dd:ee:ff or
aa-bb-cc-dd-ee-ff where aa, bb, cc, dd, ee, and ff are hexadecimal numbers. Allowed values are
any non-broadcast, non-multicast MAC and non-IEEE reserved MAC addresses.
master-int-inherit
Syntax [no] master-int-inherit
Context config>service>ies>if>vrrp
Description This command allows the master instance to dictate the master down timer (non-owner context only).
Default no master-int-inherit
message-interval
Syntax message-interval {[seconds] [milliseconds milliseconds]}
no message-interval
Context config>service>ies>if>vrrp
Description This command sets the advertisement timer and indirectly sets the master down timer on the virtual
router instance. The message-interval setting must be the same for all virtual routers participating as a
virtual router. Any VRRP advertisement message received with an Advertisement Interval field
different than the virtual router instance configured message-interval value will be silently discarded.
The message-interval command is available in both non-owner and owner vrrp virtual-router-id
nodal contexts. If the message-interval command is not executed, the default message interval of 1
second will be used.
The no form of this command restores the default message interval value of 1 second to the virtual
router instance.
Parameters seconds — The number of seconds that will transpire before the advertisement timer expires.
Values 1 — 255
Default 1
To Next Page
Loading...
