VPRN Service Configuration Commands
Page 1216 7750 SR OS Services Guide
startup-wait-time
Syntax [no] startup-wait-time [min minutes] [sec seconds]
Context config>service>vprn>dhcp>server>failover
Description This command specifies the startup wait time. The startup wait time is the time that one server
attempts to contact the partner server. During this time, the server is unresponsive to DHCP client
requests.
Parameters min minutes — Specifies the minute parameter of the startup wait time feature.
Values 1 — 59
sec seconds — Specifies the seconds parameter of the startup wait time feature.
Values 1 — 59
disable-force-renews
Syntax [no] disable-force-renews
Context config>service>vprn>dhcp>server
Description This command enables the sending of sending forcerenew messages.
The no form of the command disables the sending of forcerenew messages.
Default no disable-force-renews
pool
Syntax pool pool-name [create]
no pool pool-name
Context config>service>vprn>dhcp>server
Description This command configures a DHCP address pool on the router.
Default none
Parameters pool name — Specifies the name of this IP address pool. Allowed values are any string up to 32
characters long composed of printable, 7-bit ASCII characters.
create — Keyword used to create the entity. The create keyword requirement can be enabled/
disabled in the environment>create context.
To Next Page
Loading...
