VPRN Service Configuration Commands
Page 1220 7750 SR OS Services Guide
lease-renew-time
Syntax lease-renew-time [days days] [hrs hours] [min minutes] [sec seconds]
no lease-renew-time
Context config>service>vprn>dhcp>server>pool>options
Description This command configures the time the client transitions to a renew state.
The no form of the command removes the time from the configuration.
Default none
Parameters time — Specifies the lease renew time.
Values days: 0 — 3650
hours: 0 — 23
minutes: 0 — 59
seconds 0 — 59
lease-time
Syntax lease-time [days days] [hrs hours] [min minutes] [sec seconds]
no lease-time
Context config>service>vprn>dhcp>server>pool>options
Description This command configures the amount of time that the DHCP server grants to the DHCP client
permission to use a particular IP address.
The no form of the command removes the lease time parameters from the configuration.
Default none
Parameters time — Specifies the lease time.
Values days : 0 — 3650
hours 0 — 23
minutes: 0 — 59
seconds 0 — 59
netbios-name-server
Syntax netbios-name-server ip-address [ip-address...(up to 4 max)]
no netbios-name-server
Context config>service>vprn>dhcp>server>pool>options
Description This command configures up to four Network Basic Input/Output System (NetBIOS) name server IP
addresses.
Default none
To Next Page
Loading...
