Virtual Private Routed Network Services
7750 SR OS Services Guide Page 1257
renew-timer
Syntax renew-timer seconds
no renew-timer
Context config>service>vprn>sub-if>grp-if>ipv6>dhcp6>proxy-server
Description This command configures the renew-timer (T1), the time at which the client contacts the server from
which the addresses in the IA_NA or IA_PD were obtained to extend the lifetimes of the addresses or
prefixes assigned to the client.
Default 1800
Parameters seconds — Specifies the time duration relative to the current time, expressed in units of seconds. A
value of zero leaves the renew-time at the discretion of the client.
Values 0-604,800
rebind-timer
Syntax rebind-timer seconds
no rebind-timer
Context config>service>vprn>sub-if>grp-if>ipv6>dhcp6>proxy-server
Description This command configures the rebind-timer (T2), the time at which the client contacts any available
server to extend the lifetimes of the addresses or prefixes assigned to the client.
Default 2880
Parameters seconds — T2 is a time duration relative to the current time. A value of zero leaves the rebind-time at
the discretion of the client.
Values 0-1,209,600
preferred-lifetime
Syntax preferred-lifetime [seconds | infinite]
no preferred-lifetime
Context config>service>vprn>sub-if>grp-if>ipv6>dhcp6>proxy-server
Description The preferred lifetime for the IPv6 prefix or address in the option, expressed in units of seconds.
When the preferred lifetime expires, any derived addresses are deprecated.
Default 3600
Parameters seconds — Specifies a decimal time interval in seconds.
Values 600-424967295
infinite — Specifies a 0xffffffff value, Dec = 4294967295
To Next Page
Loading...
