Alcatel-Lucent 7750 SR - Page 1260

VPRN Service Configuration Commands
Page 1260 7750 SR OS Services Guide
mtu
Syntax mtu bytes
no mtu
Context config>service>vprn>sub-if>group-if>ipv6>router-ad
Description This command configures the MTU for the nodes to use to send packets on the link.
Default no mtu
Parameters bytes — Specifies the MTU for the nodes to use to send packets on the link.
Values 1280-9212
other-stateful-configuration
Syntax [no] other-stateful-configuration
Context config>service>vprn>sub-if>group-if>ipv6>router-ad
Description This command sets the “Other configuration” flag. This flag indicates that DHCPv6 is available for
auto-configuration of other (non-address) information such as DNS-related information or
information on other servers in the network. See RFC 3736, Stateless Dynamic Host Configuration
Protocol (DHCP) for IPv6.
Default no other-stateful-configuration
prefix-options
Syntax [no] prefix-options
Context config>service>vprn>sub-if>group-if>ipv6>router-ad
Description This command configures router advertisement parameters for IPv6 prefixes returned via RADIUS
Framed-IPv6-Prefix. All prefixes will inherit these configuration parameters.
Default no prefix-options
autonomous
Syntax [no] autonomous
Context config>services>vprn>sub-if>group-if>ipv6>router-ad>prefix-op
Description This command specifies whether the prefix can be used for stateless address auto-configuration.
Default no autonomous