VPRN Service Configuration Commands
Page 1262 7750 SR OS Services Guide
Parameters milliseconds — The length of time the router should be considered reachable for default router
selection.
Values 0-3,600,000
retransmit-time
Syntax retransmit-time milliseconds
no retransmit-time
Context config>services>vprn>sub-if>group-if>ipv6>router-ad
Description This command configures the retransmission frequency of neighbor solicitation messages.
Default no retransmit-time
Parameters milliseconds — Specifies how often the retransmission should occur.
Values 0-1,800,000
router-lifetime
Syntax router-lifetime seconds
router-lifetime no-default-router
no router-lifetime
Context config>services>vprn>sub-if>group-if>ipv6>router-ad
Description This command sets the router lifetime. A value of zero indicates this router should not be used by
hosts as a default router.
Default 4500
Parameters seconds — Specifies how long this router is valid for default router selection.
Values 2700-9000
renew-timer
Syntax renew-timer seconds
no renew-timer
Context config>services>vprn>sub-if>group-if>ipv6>dhcpv6
Description This command configures the renew-timer (T1). The time at which the client contacts the server from
the addresses in the IA_NA or IA_PD were obtained to extend the lifetimes of the addresses or
prefixes assigned to the client.
Default 1800
To Next Page
Loading...
