VPRN Service Configuration Commands
Page 1272 7750 SR OS Services Guide
Default None
proxy-server
Syntax proxy-server
Context config>service>if>dhcp
config>service>vprn>sub-if>grp-if>dhcp
Description This command configures the DHCP proxy server.
emulated-server
Syntax emulated-server ip-address
no emulated-server
Context config>service>vprn>if>dhcp>proxy
config>service>vprn>sub-if>grp-if>dhcp>proxy-server
Description This command configures the IP address to be used as the DHCP server address in the context of this
service. Typically, the configured address should be in the context of the subnet.
The no form of this command reverts to the default setting. The local proxy server will not become
operational without a specified emulated server address.
Parameters ip-address — Specifies the emulated server address.
Default Note that for a retail interface, the default is the local interface.
lease-time
Syntax lease-time [days days] [hrs hours] [min minutes] [sec seconds] [radius-override]
no lease-time
Context config>service>vprn>if>dhcp>proxy
config>service>vprn>sub-if>grp-if>dhcp>proxy-server
Description This command defines the length of lease-time that will be provided to DHCP clients. By default the
local-proxy-server will always make use of the lease-time information provide by either a RADIUS
or DHCP server.
The no form of this command disables the use of the lease-time command. The local-proxy-server
will use the lease-time offered by either a RADIUS or DHCP server.
Default 7 days 0 hours 0 seconds
Parameters radius-override — Specifies that the local-proxy-server will use the configured lease-time
information to provide DHCP clients.
days — Specifies the number of days that the given IP address is valid.
To Next Page
Loading...
