Alcatel-Lucent 7750 SR - Page 1278

VPRN Service Configuration Commands
Page 1278 7750 SR OS Services Guide
mtu
Syntax [no] mtu mtu-bytes
Context config>service>vprn>router-advert>if
Description This command configures the MTU for the nodes to use to send packets on the link.
Default no mtu — The MTU option is not sent in the router advertisement messages.
Parameters mtu-bytes — Specify
the MTU for the nodes to use to send packets on the link.
Values 1280 — 9212
other-stateful-configuration
Syntax [no] other-stateful-configuration
Description This command sets the "Other configuration" flag. This flag indicates that DHCPv6lite is available
for autoconfiguration of other (non-address) information such as DNS-related information or
information on other servers in the network. See RFC 3736, Stateless Dynamic Host Configuration
Protocol (DHCP) for IPv6.
Default no other-stateful-configuration
prefix
Syntax [no] prefix [ipv6-prefix/prefix-length]
Context config>service>vprn>router-advert>if
Description This command configures an IPv6 prefix in the router advertisement messages. To support multiple
IPv6 prefixes, use multiple prefix statements. No prefix is advertised until explicitly configured using
prefix statements.
Default none
Parameters ip-prefix — The IP prefix for prefix list entry in dotted decimal notation.
Values ipv4-prefix a.b.c.d (host bits must be 0)
ipv4-prefix-length 0 — 32
ipv6-prefix x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 — FFFF]H
d: [0 — 255]D
ipv6-prefix-length 0 — 128
prefix-length — Specifies a route must match the most significant bits and have a prefix length.
Values 1 — 128