VPRN Service Configuration Commands
Page 1316 7750 SR OS Services Guide
ike-policy ****
Syntax ike-policy ike-policy-id
no ike-policy
Context config>service>vprn>if>sap>ipsec-gw
config>service>vprn>ipsec-interface>sap>tunnel>dynamic-keying
Description This command configures the IKE policy for the gateway.
Parameters ike-policy-id — Specifies the IKE policy ID.
Values 1 — 2048
local-gateway-address
Syntax local-gateway-address ip-address
no local-gateway-address
Context config>service>vprn>if>sap>ipsec-gw
Description This command configures the ipsec-gateway local address.
Parameters ip-address — Specifies the IP unicast address.
pre-shared-key
Syntax pre-shared-key key
no pre-shared-key
Context config>service>vprn>if>sap>ipsec-gw
config>service>vprn>ipsec-interface>sap>tunnel>dynamic-keying
Description This command specifies the shared secret between the two peers forming the tunnel.
Parameters key — Specifies a pre-shared-key for dynamic-keying.
multi-service-site
Syntax multi-service-site customer-site-name
no multi-service-site customer-site-name
Context config>service>vprn>if>sap
config>service>vprn>sub-if>grp-if>sap
Description This command creates a new customer site or edits an existing customer site with the customer-site-
name parameter. A customer site is an anchor point to create an ingress and egress virtual scheduler
hierarchy. When a site is created, it must be assigned to a chassis slot or port with the exception of the
To Next Page
Loading...
