Virtual Private Routed Network Services
7750 SR OS Services Guide Page 1371
The no form of the command used at the global level disables route damping.
The no form of the command used at the group level reverts to the value defined at the global level.
The no form of the command used at the neighbor level reverts to the value defined at the group level.
When damping is enabled and the route policy does not specify a damping profile, the default
damping profile is used. This profile is always present and consists of the following parameters:
Half-life: 15 minutes
Max-suppress: 60 minutes
Suppress-threshold:3000
Reuse-threshold 750
Default no damping — Learned route damping is disabled.
disable-4byte-asn
Syntax [no] disable-4byte-asn
Context config>service>vprn>bgp
config>service>vprn>bgp>group
config>service>vprn>bgp>group>neighbor
Description This command disables the use of 4-byte ASNs. It can be configured at all 3 level of the hierarchy so
it can be specified down to the per peer basis.
If this command is enabled 4-byte ASN support should not be negotiated with the associated remote
peer(s).
The no form of the command resets the behavior to the default which is to enable the use of 4-byte
ASN.
disable-client-reflect
Syntax [no] disable-client-reflect
Context config>service>vprn>bgp
config>service>vprn>bgp>group
config>service>vprn>bgp>group>neighbor
Description This command disables the reflection of routes by the route reflector to the group or neighbor. This
only disables the reflection of routes from other client peers. Routes learned from non-client peers are
still reflected to all clients.
The no form re-enables client reflection of routes.
Default no disable-client-reflect — Client routes are reflected to all client peers.
To Next Page
Loading...
