VPRN Service Configuration Commands
Page 1374 7750 SR OS Services Guide
export
Syntax export policy [policy...]
no export
Context config>service>vprn>bgp
config>service>vprn>bgp>group
config>service>vprn>bgp>group>neighbor
config>service>vprn>rip
config>service>vprn>rip>group
config>service>vprn>rip>group>neighbor
Description This command specifies the export policies to be used to control routes advertised to BGP neighbors.
When multiple policy names are specified, the policies are evaluated in the order they are specified. A
maximum of five (5) policy names can be configured. The first policy that matches is applied.
Note that if a non-existent route policy is applied to a VPRN instance, the CLI generates a warning
message. This message is only generated at an interactive CLI session and the route policy
association is made. No warning message is generated when a non-existent route policy is applied to
a VPRN instance in a configuration file or when SNMP is used.
The no form of this command removes all route policy names from the export list.
Default no export — BGP advertises routes from other BGP routes but does not advertise any routes from
other protocols unless directed by an export policy.
Parameters policy — A route policy statement name.
family
Syntax family [ipv4] [ipv6]
no family
Context config>service>vprn>bgp
config>service>vprn>bgp>group
config>service>vprn>bgp>group>neighbor
Description This command configures the IP family capability.
The no form of the command reverts to the default.
Default no family
Parameters ipv4 — Provisions IPv4 support.
ipv6 — Provisions IPv6 support..
To Next Page
Loading...
