VPRN Service Configuration Commands
Page 1398 7750 SR OS Services Guide
retransmit-interval
Syntax retransmit-interval seconds
no retransmit-interval
Context config>service>vprn>ospf>area>interface
config>service>vprn>ospf>area>virtual-link
config>service>vprn>ospf3>area>interface
config>service>vprn>ospf3>area>virtual-link
config>service>vprn>ospf>area>sham-link
Description This command specifies the length of time, in seconds, that OSPF will wait before retransmitting an
unacknowledged link state advertisement (LSA) to an OSPF neighbor.
The value should be longer than the expected round trip delay between any two routers on the
attached network. Once the retransmit-interval expires and no acknowledgement has been received,
the LSA will be retransmitted.
The no form of this command reverts to the default interval.
Default retransmit-interval 5
Parameters seconds — The retransmit interval in seconds expressed as a decimal integer.
Values 1 — 3600
transit-delay
Syntax transit-delay seconds
no transit-delay
Context config>service>vprn>ospf>area>interface
config>service>vprn>ospf3>area>interface
config>service>vprn>ospf>area>virtual-link
config>service>vprn>ospf3>area>virtual-link
config>service>vprn>ospf>area>sham-link
Description This command configures the estimated time, in seconds, that it takes to transmit a link state
advertisement (LSA) on the interface or virtual link or sham-link.
The no form of this command reverts to the default delay time.
Default transit-delay 1
Parameters seconds — The transit delay in seconds expressed as a decimal integer.
Values 0 — 3600
To Next Page
Loading...
