Alcatel-Lucent 7750 SR - Page 1476

VSM Path Commands
Page 1476 7750 SR OS Services Guide
Parameters path-weight — The path-weight parameter is required and is used by the system to determine the
scheduling percentage for both paths. Changing the path-weight for one path affects both paths
scheduling percentage. The resulting scheduling percentage changes are applied to all CCAs in
the CCAG membership list.
Values 1 to 100
Default 50
sap-sap
Syntax sap-sap
Context config cca>ccag ccag-id>path {a | b}
Description This command changes the current CLI context to the path SAP-SAP nodal context. This context
contains the ingress and egress buffer pool configuration commands. The sap-sap>path context is
associated with all SAPs defined on the CCAG path (alpha or beta depending on the path context)
that cross connect to a SAP on the other path.
The CCA path SAP-SAP nodal context always exists and cannot be removed.
mac
Syntax [no] mac mac-address
Context config>vsm>ccag ccag-id>path {a | b}
config>vsm>ccag ccag-id>path {a | b}>sap-net
config>vsm>ccag ccag-id>path {a | b}>net-sap
Description This command overrides the default MAC address for the path’s context.
The no form of the command returns the in-use MAC address for the path’s context to the default
MAC from the chassis MAC pool.
Parameters mac-address — Defines the IEEE MAC address that is to be associated with the path’s context.
Values Any valid IEEE MAC source MAC address
(6 byte address expressed in hexadecimal notation with each byte separated by a
dash (-)).
Default The path’s default sap-sap MAC address is derived from the chassis MAC address
pool.