Service Commands
7750 SR OS Services Guide Page 1505
Sample Output
*A:ALA-12# show service sdp
==============================================================================
Services: Service Destination Points
==============================================================================
SdpId Adm MTU Opr MTU IP address Adm Opr Deliver Signal
------------------------------------------------------------------------------
10 4462 4462 10.20.1.3 Up Dn NotReady MPLS TLDP
40 4462 1534 10.20.1.20 Up Up MPLS TLDP
60 4462 1514 10.20.1.21 Up Up GRE TLDP
100 4462 4462 180.0.0.2 Down Down GRE TLDP
500 4462 4462 10.20.1.50 Up Dn NotReady GRE TLDP
------------------------------------------------------------------------------
Number of SDPs : 5
==============================================================================
*A:ALA-12#
*A:Dut-A# show service sdp 1 detail
==============================================================================
Service Destination Point (Sdp Id : 1) Details
------------------------------------------------------------------------------
Sdp Id 1 -(10.20.1.3)
------------------------------------------------------------------------------
Description : epipe sdp 1 for lspId 00:00:00:01:00:00:00:00
SDP Id : 1 SDP Source : manual
Admin Path MTU : 0 Oper Path MTU : 1492
Far End : 10.20.1.3 Delivery : MPLS
Admin State : Up Oper State : Up
Signaling : TLDP Metric : 0
Acct. Pol : None Collect Stats : Disabled
Last Status Change : 12/08/2008 22:54:30 Adv. MTU Over. : No
Last Mgmt Change : 12/08/2008 22:54:01 VLAN VC Etype : 0x8100
Bw BookingFactor : 100 PBB Etype : 0x88e7
Oper Max BW(Kbps) : 1000 Avail BW(Kbps) : 1000
Flags : None
Class Forwarding
Indicates the admin state of class-based forwarding on this SDP. When the
value is true, class-based forwarding is enabled.
EnforceDSTELspFc
Specifies whether service manager must validate with RSVP the support of
the FC by the LSP.
Default LSP
Specifies the LSP ID that is used as a default when class-based forwarding is
enabled on this SDP. This object must be set when enabling class-based for-
warding.
Multicast LSP
Displays the LSP ID that all multicast traffic will be forwarded on when
class-based forwarding is enabled on this SDP. When this object has its
default value, multicast traffic will be forwarded on an LSP according to its
forwarding class mapping.
Number of SDPs
The total number of SDPs displayed according to the criteria specified.
Label Description (Continued)
To Next Page
Loading...
