Alcatel-Lucent 7750 SR - Page 1508

Show, Clear, Debug Commands
Page 1508 7750 SR OS Services Guide
*A:MV-SR12>config>service>vprn#
When network domains are configured, the SDP egress interface state can be verified by using the following
command:
*A:Dut-T# show service sdp egressifs
===============================================================================
SDP Egress Ifs State Table
===============================================================================
SDP Id Network Domain State
-------------------------------------------------------------------------------
100 net1 consistent
-------------------------------------------------------------------------------
SDPs : 1
===============================================================================
*A:Dut-Tr#
sdp-using
Syntax sdp-using [sdp-id[:vc-id] | far-end ip-address]
Context show>service
Description This command displays services using SDP or far-end address options.
Parameters sdp-id — Displays only services bound to the specified SDP ID.
Values 1 — 17407
vc-id — The virtual circuit identifier.
Values 1 — 4294967295
far-end ip-address — Displays only services matching with the specified far-end IP address.
Default Services with any far-end IP address.
Output Show Service SDP Using X — The following table describes show service sdp-using output fields.
Label Description
Svc ID
The service identifier.
Sdp ID
The SDP identifier.
Type
Type of SDP: spoke or mesh.
Far End
The far end address of the SDP.
Oper State
The operational state of the service.