Alcatel-Lucent 7750 SR - Page 1517

Service Commands
7750 SR OS Services Guide Page 1517
cfm-stack-table
Syntax cfm-stack-table [port [port-id [vlan vlan-id]] | sdp sdp-id[:vc-id]] [level 0..7] [direction up | down]
Context show>eth-cfm
Description This command displays stack-table information.
Parameters port port-id — Displays the bridge port or aggregated port on which MEPs or MHFs are configured.
vlan vlan-id — Displays the associated VLAN ID.
sdp sdp-id[:vc-id] — Displays the SDP binding for the bridge.
level — Display the MD level of the maintenance point.
Values 0 — 7
direction up | down — Displays the direction in which the MP faces on the bridge port.
Output Show eth-cfm CFM Stack Table Command Output — The following table describes show eth-cfm
CFM stack table command output fields:
Sample Output
*A:node-1# show eth-cfm cfm-stack-table
========================================================================
eth-cfm CFM SAP Stack Table
========================================================================
Sap Level Dir Md-index Ma-index Mep-id Mac-address
------------------------------------------------------------------------
1/2/1 4 Up 1 1 5 ac:48:01:02:00:01
1/2/3:100 4 Up 1 1 1 ac:48:01:02:00:03
1/2/3:* 4 Up 1 1 4 ac:48:01:02:00:03
========================================================================
eth-cfm CFM SDP Stack Table
========================================================================
Sdp Level Dir Md-index Ma-index Mep-id Mac-address
Label Description
Sap
Displays associated SAP IDs.
Sdp
Displays the SDP binding for the bridge.
Level Dir
Displays the MD level of the maintenance point.
Md-index
Displays the the maintenance domain (MD) index.
Ma-index
Displays the the maintenance association (MA) index.
Mep-id
Displays the integer that is unique among all the MEPs in the same
MA.
Mac-address
Displays the MAC address of the MP.