Alcatel-Lucent 7750 SR - Page 1528

Show, Clear, Debug Commands
Page 1528 7750 SR OS Services Guide
sap-using interface [ip-address | ip-int-name]
sap-using [ingress | egress] atm-td-profile td-profile-id
sap-using [ingress | egress] filter filter-id
sap-using [ingress | egress] qos-policy qos-policy-id
sap-using authentication-policy policy-name
Context show>service
Description This command displays SAP information.
If no optional parameters are specified, the command displays a summary of all defined SAPs.
The optional parameters restrict output to only SAPs matching the specified properties.
Parameters ingress — Specifies matching an ingress policy.
egress — Specifies matching an egress policy.
qos-policy qos-policy-id — The ingress or egress QoS Policy ID for which to display matching
SAPs.
Values 1 — 65535
atm-td-profile td-profile-id — Displays SAPs using this traffic description.
filter filter-id — The ingress or egress filter policy ID for which to display matching SAPs.
Values 1 — 65535
sap sap-id — Specifies the physical port identifier portion of the SAP definition. See Common CLI
Command Descriptions on page 1933 for command syntax.
interface ip-address — The IP address of the interface for which to display matching SAPs.
Values 1.0.0.0 — 223.255.255.255
interface ip-int-name — The IP interface name for which to display matching SAPs.
authentication-policy policy name — Specifies an existing authentication policy.
Output Show Service SAP — The following table describes show service SAP output fields:
Label Description
Port ID
The ID of the access port where the SAP is defined.
Svc ID
The service identifier.
Sap MTU
The SAPMTU value.
Ing. QoS
The SAP ingress QoS policy number specified on the ingress SAP.
Ing Fltr
The MAC or IP filter policy ID applied to the ingress SAP.
Egr. QoS
The SAP egress QoS policy number specified on the egress SAP.
Egr. Fltr
The MAC or IP filter policy ID applied to the egress SAP.
Adm
The administrative state of the SAP.