Page 158 7750 SR OS Services Guide
If send-queries is not enabled on this SAP or SDP, the configured query-response-interval value is
ignored.
Default 10
Parameters seconds — Specifies the length of time to wait to receive a response to the host-query message from
the host.
Values 1 — 1023
robust-count
Syntax robust-count robust-count
no robust-count
Context config>service>pw-template>igmp-snooping
Description If the send-queries command is enabled, this parameter allows tuning for the expected packet loss.
The robust-count variable allows tuning for the expected packet loss on a subnet and is comparable to
a retry count.
If send-queries is not enabled, this parameter will be ignored.
Default 2
Parameters robust-count — Specifies the robust count for the SAP or SDP.
Values 2 — 7
send-queries
Syntax [no] send-queries
Context config>service>pw-template>igmp-snooping
Description This command specifies whether to send IGMP general query messages.
When send-queries is configured, all type of queries generate ourselves are of the configured version.
If a report of a version higher than the configured version is received, the report will get dropped and
a new wrong version counter will get incremented.
If send-queries is not configured, the version command has no effect. The version used on that SAP/
SDP will be the version of the querier. This implies that, for example, when we have a v2 querier, we
will never send out a v3 group or group-source specific query when a host wants to leave a certain
group.
Default no send-queries
version
Syntax version version
To Next Page
Loading...
