Alcatel-Lucent 7750 SR - Page 1587

VPLS Show Commands
7750 SR OS Services Guide Page 1587
sap-using
Syntax sap-using interface [ip-address | ip-int-name]
sap-using [ingress | egress] filter filter-id
sap-using [sap sap-id]
sap-using [ingress | egress] atm-td-profile td-profile-id
sap-using authentication-policy auth-plcy-name
sap-using [ingress | egress] qos-policy qos-policy-id
Context show>service
Description This command displays SAP information.
If no optional parameters are specified, the command displays a summary of all defined SAPs.
The optional parameters restrict output to only SAPs matching the specified properties.
Parameters ingress — Specifies matching an ingress policy.
egress — Specifies matching an egress policy.
qos-policy qos-policy-id — The ingress or egress QoS Policy ID for which to display matching
SAPs.
Values 1 — 65535
atm-td-profile td-profile-id — Displays SAPs using this traffic description.
filter filter-id — The ingress or egress filter policy ID for which to display matching SAPs.
Values 1 — 65535
authentication auth-plcy-name — The session authentication policy for which to display matching
SAPs.
sap-id — Specifies the physical port identifier portion of the SAP definition. See Common CLI
Command Descriptions on page 1933 for command syntax.
interface — Specifies matching SAPs with the specified IP interface.
ip-address — The IP address of the interface for which to display matching SAPs.
Values 1.0.0.0 — 223.255.255.255
ip-int-name — The IP interface name for which to display matching SAPs.
Output Show Service SAP — The following table describes show service SAP output fields:
i
Label Description
Port ID
The ID of the access port where the SAP is defined.
Svc ID
The service identifier.
SapMTU
The SAP MTU value.
I.QoS
The SAP ingress QoS policy number specified on the ingress SAP.
I.MAC/IP
The MAC or IP filter policy ID applied to the ingress SAP.