VPLS Show Commands
7750 SR OS Services Guide Page 1589
sdp
Syntax sdp [sdp-id | far-end ip-address] [detail | keep-alive-history]
sdp [sdp-id[:vc-id] | far-end ip-address]
sdp [sdp-id | far-end ip-addr] [detail | keep-alive-history]
Context show>service>id
Description This command displays information for the SDPs associated with the service.
If no optional parameters are specified, a summary of all associated SDPs is displayed.
Parameters sdp-id — Displays only information for the specified SDP ID. An SDP is a logical mechanism that
ties a far-end 7750 SR to a particular service without having to specifically define far end SAPs.
Each SDP represents a method to reach a 7750 SR router.
Default All SDPs.
Values 1 — 17407
far-end ip-addr — Displays only SDPs matching with the specified system IP address of the far-end
destination 7750 SR router for the Service Distribution Point (SDP) that is the termination point
for a service.
Default SDPs with any far-end IP address.
detail — Displays detailed SDP information.
Output Show Service SDP — The following table describes show service-id SDP output fields.
Label Description
Sdp Id
The SDP identifier.
Type
Indicates whether the SDP is a spoke
Split Horizon
Group
Name of the split horizon group where the SDP belongs.
VC Type
Displays the VC type, ether or vlan.
VC Tag
Displays the explicit dot1Q value used when encapsulating to the SDP
far end.
I. Lbl
The VC label used by the far-end device to send packets to this device
in this service by the SDP.
Admin Path MTU
The operating path MTU of the SDP is equal to the admin path MTU
(when one is set) or the dynamically computed tunnel MTU, when no
admin path MTU is set (the default case.)
Oper Path MTU
The actual largest service frame size (in octets) that can be transmitted
through this SDP to the far-end router, without requiring the packet to
be fragmented.
Far End
Specifies the IP address of the remote end of the GRE or MPLS tunnel
defined by this SDP.
To Next Page
Loading...
