Alcatel-Lucent 7750 SR - Page 1591

VPLS Show Commands
7750 SR OS Services Guide Page 1591
sdp-using
Syntax sdp-using [sdp-id[:vc-id] | far-end ip-address]
Context show>service
Description This command displays services using SDP or far-end address options.
Parameters sdp-id — Displays only services bound to the specified SDP ID.
Values 1 — 17407
vc-id — The virtual circuit identifier.
Values 1 — 4294967295
far-end ip-address — Displays only services matching with the specified far-end IP address.
Default Services with any far-end IP address.
Output Show Service SDP Using — The following table describes service-using output fields.
Sample Output
*A:ALA-1# show service sdp-using 300
===============================================================================
Service Destination Point (Sdp Id : 300)
===============================================================================
SvcId SdpId Type Far End Opr State I.Label E.Label
-------------------------------------------------------------------------------
1 300:1 Mesh 10.0.0.13 Up 131071 131071
2 300:2 Spok 10.0.0.13 Up 131070 131070
100 300:100 Mesh 10.0.0.13 Up 131069 131069
101 300:101 Mesh 10.0.0.13 Up 131068 131068
102 300:102 Mesh 10.0.0.13 Up 131067 131067
-------------------------------------------------------------------------------
Number of SDPs : 5
-------------------------------------------------------------------------------
*A:ALA-1#
Label Description
Svc ID
The service identifier.
Sdp ID
The SDP identifier.
Type
Specifies the type of SDP: Spoke or Mesh.
Far End
The far-end address of the SDP.
Oper State
The operational state of the service.
Ingress Label
The label used by the far-end device to send packets to this device in
this service by this SDP.
Egress Label
The label used by this device to send packets to the far-end device in
this service by this SDP.