Show, Clear, Debug Commands
Page 1642 7750 SR OS Services Guide
l2pt
Syntax l2pt disabled
l2pt [detail]
Context show>service>id
Description This command displays Layer 2 Protocol Tunnel (L2-PT) route information associated with this
service.
Parameters disabled — Displays only entries with termination disabled. This helps identify configuration errors.
detail — Displays detailed information.
Output Show L2PT Fields — The following table describes show L2PT output fields:
Label Description
Service id
Displays the 24 bit (0..16777215) service instance identifier for the
service.
L2pt-term enabled
Indicates if L2-PT-termination and/or Bpdu-translation is in use in this
service by at least one SAP or spoke SDP binding. If in use, at least
one of L2PT-termination or Bpdu-translation is enabled.
When enabled it is not possible to enable STP on this service.
L2pt-term dis-
abled
Indicates that L2-PT-termination is disabled.
Bpdu-trans auto
Specifies the number of L2-PT PDU's are translated before being sent
out on a port or sap.
Bpdu-trans dis-
abled
Indicates that Bpdu-translation is disabled.
SAPs
Displays the number of SAPs with L2PT or BPDU translation enabled
or disabled.
SDPs
Displays the number of SDPs with L2PT or BPDU translation enabled
or disabled.
Total
Displays the column totals of L2PT entities.
SapId
The ID of the access point where this SAP is defined.
L2pt-termination
Indicates whether L2pt termination is enabled or disabled.
Admin Bpdu-trans-
lation
Specifies whether Bpdu translation is administratively enabled or dis-
abled.
Oper Bpdu-
translation
Specifies whether Bpdu translation is operationally enabled or dis-
abled.
SdpId
Specifies the SAP ID.
To Next Page
Loading...
